7. Install the switch and power cable assembly onto the
upper handle section using the two supplied bolts
(ST3.9 x 19). (Fig. 2-6)
8. Use the two supplied cable clips (3) to secure the
cord. (Fig. 2-7)
WARNING:
If any parts are damaged or missing do
not operate this product until the parts are replaced.
Failure to heed this warning could result in serious
personal injury. Call our customer service help line at 1
-800-313-5111 for assistance
WARNING:
Do not attempt to modify this product or
create accessories not recommended for use with
this product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
WARNING:
Do not connect to power supply until
assembly is complete. Failure to comply could
result in accidental starting and possible serious
personal injury.
ASSEMBLY
6
This product must be assembled correctly before use.
1. Remove the screws (M5 X 12) and washers from
wheel frame. Insert the wheels on the axle of wheel
frame, then attach washers and screws (M5 X 12)
to secure. (Fig. 2-1)
2. Press the wheel covers into the wheel and cover the
ends of the axles. You may use a hammer to seat
them securely into the wheels. (Fig. 2-1)
3. To lower wheel frame, push the lock button on back
of motor housing to release the frame (Step A). Low-
er the wheel frame (Step B) and pull out the lock pin
on lower handle section (Step C). Align lock pin to
the hole in wheel frame then release it to lock the
wheel frame in position. (Fig. 2-2)
4. Slide the cord retainer (5) onto the center handle
section (4). (Fig. 2-3)
5. Attach the center handle section (4) to the lower
handle sections (9) using the two supplied M6 X 45
bolts (6) and wing nuts (7). (Fig. 2-4)
6. Fasten the upper handle section (1) to the center
handle section (4) using the two supplied M6 X 45
bolts (6) and wing nuts (7) (Fig. 2-5).
ST3.9 X 19
M5 X 12
M6 X 45
3
4
5
4
M6 X 45
4
7
7
9
10
5
B
A
C