When transporting spreader from location to location,
make sure the on/off control lever is locked in the “OFF”
position securing the lever with the hitch pin.
Model BF
lss
only-Ice melt products
can be applied using a normal
width, or a narrow band can be
applied by closing the trim control
and the auxiliary shut-off slide,
leaving only the center port open as
shown.
Use Swath Width
on Package or Adjust
per Operator’s
Walking Speed
Normal spreading of material requires no adjustment unless otherwise stated on the package. In those cases where the
spread pattern has shifted, the pattern can be adjusted. If the pattern is heavier to the left (as viewed from the operating
position), loosen the knob and move the control plate in toward the hopper. If it is heavy to the right, move the control plate
out away from the hopper. Tighten knob after each adjustment is made. A scale is stamped into the control plate to provide
settings.
Normal Pattern
Pattern Heavy
Left
Pattern Heavy
Right
Knob
Scale
Control Plate
