ASSEMBLY and OPERATING INSTRUCTIONS
for
EarthWay
E
V
-N-S
PRED
®
C25HD & C25HDS
Tow Broadcast Spreaders
rev 10-07
HELPFUL HINTS:
READ THE DIRECTIONS BEFORE ASSEMBLY
If your spreader does not spread evenly, be sure the FRONT on the gear box
toward the tow hitch
. The impeller must turn clock-
wise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller plate after each use. Fertilizer
stuck on the impeller blades will cause uneven spreading.
Your spreader is designed to be towed at three miles per hour—maximum. Slower or faster speeds will change the spread patterns.
Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your spreader thoroughly after each use. Wash be-
tween the shut off plate and bottom of the hopper.
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
Your new spreader has been shipped semi-assembled
resulting in easy assembly and a short time before it is
ready for use.
Fig 1
Assembly
Step 1:
Remove your spreader from the shipping carton
Fig 2
.
Step 2:
Remove the 2 bolts that are in the frame
Fig 3.
and then lift the tongue into position to allow
the bolts just removed to go through the frame
and the tongue as shown in
Fig 4.
Step 3:
Tighten the 2 bolts in
Fig 5
, then tighten all
other frame bolts as seen in
Fig 6.
Pt. #52155
P
LEASE
C
ALL
IF
YOU
ARE
MISSING
ANY
PARTS
,
HAVE
ANY
DIFFICULTY
IN
ASSEMBLY
,
OR
HAVE
ANY
QUESTIONS
REGARDING
THE
SAFE
OPERATION
OF
THIS
SPREADER
. T
HIS
MODEL
INCLUDES
LIFETIME
TECHNICAL
SUPPORT
.
S
UPPORT
H
OT
L
INE
: 574-848-7491 or 800-294-0671 E
