Assembly
and
Operation Instructions
Moun
ng
Steps
Steps
1. Tape the drilling template on the wall at a convenient height, making sure the
holes are between studs.
2. Check the hole centers with the level to ensure they are plumb.
3. Drill (4) four holes with a 10mm (3/8in) masonry drill bit on the template centers.
4. Tap plas c anchors (B.3) into holes with a hammer or mallet.
5. Fasten the moun ng bracket with four lag bolts and washer to the wall or
mber post and ensure drive moun ng screws into the plas c anchors) in
wall.
6. Hang the hose reel on the wall bracket and secure it by inser ng the
mount tube.
7. Connect with inlet hose end with the water source.
EarthWay 14100 – 100’ Hose Reel
PAGE
3
the
flat washer
1. Using your electric drill, 10mm (3/8") masonry drill bit and bubble level, drill the hole-
pattern shown, making each hole about 2" deep.
insert in this
B.1
lock washer
sleeve
Take
care
to
ensure
that
the
pattern
is
level
.
2. Remove the nut, lock washer, and flat washer from the expansion bolt (B.1).
3. Insert the expansion bolts (with sleeves) into the holes.
4. Mount the Wall Bracket (D) on to the bolts, then assembled the nut, lock washer,
And flat washer. Tighten the nut until the expansion bolt is secure.
6. Connect leader hose to water source.
208mm (8 ")
80cm (32")
(recommended)
76mm (3")
nut
expansion bolt
5. Hang Hose Reel (C) on wall bracket (D).
direction
D
B.1
WARNING:
Ensure there are no live electrical wires or
plumbing in the wall at the location you are drilling.
CAUTION:
When using power tools such as an
electric drill, please wear eye protection.
Installation:
Wall
Use this method for stone or brick walls...