Assembly and Operation Instructions
Earthway_1001-B Manual_v1
PAGE 2
Assembly Steps
REAR WHEEL
Step 1:
Lower kick stand at front to hold planter
upright.
Step 2:
Remove nut, bolt, and axle (22, 18, & 25) from
frame.
Step 3:
Insert axle through rear wheel (17), place
between frame, and line up with holes in end of frame.
Step 4:
Reinstall bolt and nut (18 & 22), and tighten.
HANDLE
Step 1:
Remove nuts and bolts from Plastic Bag.
(These are special lock nuts. A wrench will be required to
remove and install them).
Step 2:
Bolt handle (8) in place using bolt & nut (13 &
14) as shown in Figure 1, Page 3 for illustration.
Step 3:
Install the Row Marker Retainer Clip (10) from
the front to the back and press into place in the holes on
the handle.
ROW MARKER
Step 1:
Place row marker shaft (1) in front of row
marker bracket and line up holes.
Step 2:
Insert clevis pin (7) through row marker shaft
(1) and row marker bracket, and insert hair pin clip (6)
through clevis pin. When not in use, secure the row
marker shaft to the Handle Bracket w/Clip (10) to hold in
place.
Step 3:
A cord may be tied to the Handle Bracket
w/Clip(10) and row marker shaft (1) for lowering and
raising the row marker.