earth safe
Fuel Systems for Critical Power
4 of 16
EMERGENCY POWER FUEL SYSTEMS
Model M20
Duplex Fuel Pump
INSTALLATION, OPERATION, AND MAINTENANCE
Safety notices – General Safety Rules – Symbols
(danger-warning-caution)
SAFETY INFORMATION AND INSTRUCTIONS
Danger
— Failure to follow the indicated instruction may result in serious injury or death.
Warning
— In addition to possible serious injury or death, failure to follow the indicated
instruction may cause damage to pump and/or other equipment.
IMPROPER INSTALLATION, OPERATION OR MAINTENANCE OF PUMP MAY CAUSE
SERIOUS INJURY OR DEATH AND/OR RESULT IN DAMAGE TO PUMP AND/OR OTHER
EQUIPMENT. EARTHSAFE’S WARRANTY DOES NOT COVER FAILURE DUE TO IMPROPER
INSTALLATION, OPERATION OR MAINTENANCE.
THIS INFORMATION MUST BE FULLY READ BEFORE BEGINNING INSTALLATION,
OPERATION OR MAINTENANCE OF PUMP AND MUST BE KEPT WITH PUMP. PUMP MUST
BE INSTALLED, OPERATED AND MAINTAINED ONLY BY SUITABLY TRAINED AND
QUALIFIED PERSONS.
THE FOLLOWING SAFETY INSTRUCTIONS MUST BE FOLLOWED AND ADHERED TO
AT ALL TIMES.
Symbol Legend:
Danger
— Failure to follow the indicated instruction may result in serious injury or death
Warning
— In addition to possible serious injury or death, failure to follow the indicated
instruction may cause damage to pump and/or other equipment.
BEFORE
opening any liquid chamber (pumping chamber, reservoir, relief valve adjusting cap
fitting, etc.) be sure that:
• Any pressure in the chamber has been completely vented through the suction or discharge
lines or other appropriate openings or connections.
• The pump drive system means (motor, turbine, engine, etc.) has been “locked out” or
otherwise been made non-operational so that it cannot be started while work is being done
on the pump.
• You know what material the pump has been handling, have obtained a material safety data
sheet (MSDS) for the material, and understand and follow all precautions appropriate for the
safe handling of the material.
DO NOT
operate pump if the suction or discharge piping is not connected.
DO NOT
place fingers into the pumping chamber or its connection ports or into any part of the
drive train if there is any possibility of the pump shafts being rotated.
Continued
