<<< Power Requirements >>>
<<< Tech Specs >>>
• Current Draw: 460mA
• For best results, please use the included 9v center-negative 1-amp DC power supply.
• To use with multiple output transformer-balanced isolated pedal-specific power supplies, Pyramids’ may be
powered from two outlets combined using a current-doubling cable.
DO NOT USE A VOLTAGE-DOUBLING
CABLE BECAUSE THAT WILL SEND 18V TO PYRAMIDS AND FRY IT LIKE AN OVEREASY EGG AT A
GREAZY SPOON DINER.
• 24-bit 96kHz A/D & D/A converters
• S/N Ratio: 115dB typical
• Input Impedance: 1M Ohm
• Output Impedance: 100 Ohm
• All analog dry signal path
• All digital wet signal path with
20Hz – 20kHz frequency response
• PCBs populated by a combination of artificial and
human intelligence in the Akron, Ohio of America.
•
Each and every Pyramids is completely
assembled, wired, and tested by total human
beans in the Great Sphinx of Akron, Ohio, which,
coincidentally, looks exactly like the cover of Iron
Maiden’s
Powerslave
.
<<< Warranty >>>
This device has a limited lifetime warranty. If it breaks, we will fix it. Should you encounter any issues, please
.
<<< LED Behavior >>>
In
Live
mode, the Activate LED is always green. When using a saved preset, the Activate LED is yellow, and
will change to red when a preset setting is changed. When saving a change to a preset or writing an entirely
new preset, the Activate LED will flash and turn yellow once the change/preset has been saved. The Tap/
Trigger LED is white and will flash in tempo regardless if the tempo is set via the Rate control or the Tap/
Trigger Footswitch. The Tap/Trigger LED is not used in both Trigger up and down modes and will remain dark.