11
For additional information email
or call 800-345-6007 M-F 8-5
Operator’s Manual
Rototiller Victory
CAUTION
Attach handle bar:
1. Locate handle bar extensions.
SEE FIGURE 4
2. Place handle bar extensions on outside of lower handle
bar mount. Line up the handle bar extension pieces
with the lower handle bar mount as shown in the decal
located on the lower handle bar mount next to the
mounting location.
SEE FIGURE 4
3. Insert one M10-1.5 x 45 bolt for each side in lower holes
of the extension pieces. The bolts will pass through the
lower hole of the lower handle bar mount. Put M10 flat
washers onto bolts.
NOTE: Always put washers on the tubing side of bolts.
4. Hand tighten M10-1.5 nuts on each bolt.
5. Now assemble the handle bar to the handle bar
extensions. Note: Handle bar goes to the outside of the
handle bar extensions.
6. Insert one M1-1.5 x 45 bolt for each side in lower holes
of the handle bar. Note: Bolts will be going through the
upper holes of the lower handle bar mount along with
the middle holes of the extensions. Put M10 flat washers
onto bolts.
7. Hand tighten M10-1.5 nuts on each bolt.
8. Insert one M10-1.5 x 25 bolt for each side in upper holes
of the handle bar. Bolts will pass through upper holes of
the extensions. Put M10 flat washers onto bolts.
9. Hand tighten M10 nuts on each bolt.
10. Tighten M10-1.5 nuts on each of the 6 bolts connecting
the handle bar, handle bar extensions and handle bar
mount together.
Attach tine side shields:
1. Locate side shields.
SEE FIGURE 5
2. Take one side shield, raise it up against one side of the tine
guard and hold in place.
3. Place a M6 flat washer onto three M6-1 x 12 bolts. Insert
these three bolts in each of the three holes of the tine
guard, making sure they also pass through the side
shield. Put an additional M6 flat washers onto the
underside of the bolts.
NOTE: The side shield needs to be below the tine hood
when they are attached together.
4. Hand tighten M6-1nuts on each bolt.
5. Tighten M6-1 nuts on each of the three bolts connecting
the two side shields to the tine guard.
6. Repeat steps 2-4 for the second side shield.
Engine preparation:
Fill Engine Crankcase with Oil:
See the engine manufacturer’s instructions for the type of
gasoline and oil to use. Before you use the unit, read the
information on safety, operation, maintenance, and storage.
1. Add oil according to engine manual.
Do not overfill.
Use a clean, high quality detergent oil. Use no special
additives with recommended oils.
Do not mix oil with
gasoline.
Oil level must be full. Check the oil level by
removing oil fill plug. Oil level should be up to the
bottom of the fill plug opening.
HANDLE
BAR
LOWER
HANDLE BAR
MOUNT
HANDLE BAR
EXTENSIONS
FIGURE 4
FIGURE 5
BOLTS AND
WASHERS
SIDE SHIELD
GEAR CASE
DIPSTICK AND
HOLE
DO NOT PUT ENGINE
OIL IN TRANSMISSION.
LUBRICANT IS
INSTALLED BY
MANUFACTURER
