PHD2200W.4
10
11
Two 30A Fuses
Speaker
Outputs
Minimum
4 Ohm
Mono
The gain knob is not a volume control.
It is designed to match the input level
of the amp to the output level of the
source unit. Over driving -clipping- the
input stage of the amp will cause
damage to the amplifier (Please refer
to table for settings).
3-way switch feeds, RCA outputs
3/4 a full range, high-pass or low-
pass signal.
3-way switch for each block
runs CH1/2 or CH3/4 in low
-pass, full-range or high-
pass mode.
Tonal controls CH3/4:
+ 12dB boost @ 12kHz
+ 18dB boost @ 45Hz
Four RCA level inputs
with a range of 0.2V to
5V. RMS.
Four RCA level inputs
crossed outputs, can be
used to feed other
amplifiers in the system
Set Xover knob to
Minimum (20Hz), &
set Xover switch to
by-pass, (full-range)
Specifications Are Subject To Change Without Notice
www.earthquakesound.com
POWER
To car chassis / ground
To remote turn on / trigger
To battery (+)
REM GND
BAT
Summary of Contents for PH2000W/D1
Page 11: ......
