Control Panel Overview continued
Earthquake Sound Corp. | (800) 576-7944 | www.earthquakesound.com
8 MiniMe DSP P10/P12
(12)
(11)
(10)
(9)
(8)
(7)
(6)
MONO
DSP
(6) Pairing
Used to reset iWoofer
lock password. To
™
remove password press/hold for 3 seconds.
The default password is “0”
(7) IR Input
Simply plug the remote eye provided in the IR
INPUT. Once plugged in, place the remote eye
anywhere in the room where it is convenient for
the user to control the amplifier using the
included remote control.
(8) AUTO/ON/OFF Switch
This is a 3-way switch. When ON, the amplifier
will remain on regardless of signal presence.
When set to AUTO, the amplifier will only turn
on when audio signal is detected. Additionally,
the amplifier will go to sleep/stand-by if it does
not detect any signal after 15 minutes. When
set to OFF, the amplifier will remain off
regardless of signal presence. Note that the
MAIN POWER switch must be ON for this
feature to work.
(9) 40Hz-160Hz Frequency
Adjustment
This knob allows user to set the subwoofer’s
cut off frequency. Signals above the set
crossover frequency will be gradually rolled off
to prevent them from interfering with the
surround speakers.
(10) DSP ON/OFF
Enable or disable iWoofer™ DSP. When
disabled the frequency adjustment knob (9)
will be active.
(11) 0-180° Phase Adjustment
This 0° - 180° switch allows user to
synchronize the subwoofer to obtain better
and more precise bass response.
(12) AC Power with Built-in Fuse
This AC line connector is fused to protect the
subwoofer from unwanted power surges. Be
sure to use the proper fuse rating when
replacing the fuse:
110-120V~60Hz: ø5x20mm, T6.3AL/250V
220-240V~50Hz: ø5x20mm, T3.15AL/250V
To access the fuse compartment, simply
unplug the subwoofer from any power source,
place a flat-head screw driver in the small
n o t c h a n d p r y i t o p e n a s
illustrated.
