ARDISAM
9
UNPACKING AND ASSEMBLY
Your rototiller comes fully assembled except for a few
parts. The following instructions will help you unpack
your tiller and assemble and adjust your tiller’s depth
regulator lever, cable tension and handlebar height. You
will need 2- 9/16” wrenches.
UNPACK TILLER
1. Open top of carton and remove handlebar assembly.
2. Find parts packet. Parts packet contains:
5- 3/8-16 x 1” hex head bolts
5- 3/8-16 locknuts
1- 5/16-18 x 3/4” hex head bolt
1- 5/16-18 locknut
1- detent pin
3. Cut open end of carton and remove machine by:
a. Removing lockpins on wheels.
b. Roll tiller from carton.
The right and left sides of your
rototiller are determined from
the operating position as you
face the direction of forward
travel.
ATTACH HANDLEBAR TO TILLER
1. Place handlebar stems on outside of transmission
cover and align lower holes.
2. Insert one 3/8”-16 x 1” bolt for each side in lower
holes.
3. Start 3/8”-16 nuts on each bolt.
4. Insert one 3/8”-16 x 1” bolt for each side in upper
holes at desired handlebar height.
5. Tighten all 3/8”-16 nuts.
height
adjustment
holes
transmission
cover
lock nuts
height
adjustment
bolts
height
adjustment
bolts
Do not try to lift the rototiller from the carton.
CAUTION
