IMPORTANT
Systems include one Headset labeled “MAIN”.
This MAIN headset must be
Turned “ON” to link the corresponding Remote headsets.
Battery
o
The microphone mute feature is controlled by
the button located on the earcup, labelled MIC.
o
Pressing the Mic button illuminates the nearby
power button to red, indicating the microphone
signal is muted.
o
Pressing the button again reactivates the mic gain
and the red LED off.
AutoMute
Operation
o
Batteries are charged via the multi-charger.
o
Insert the batteries making sure the contacts are properly aligned.
o
RED: Charging, GREEN: Fully charged.
Each new EVADE series system arrives pre-programmed. Should you need to add to
your system please visit eartec.com/EVADE-programming.
o
Click the power button on the MAIN headset. Flashing green
LED indicates power is ON.
o
Press the power button on the REMOTE headset(s).
o
The LED on all headsets will flash & then turn solid green
indicating headsets have linked.
Note: to turn off, press and hold the power button for 4-5
seconds. When LED blinks red, release.
ON / OFF Power
Volume UP / DOWN
o
To eject battery from headset, press and slide
door down to open battery compartment.
o
Insert battery as shown, close battery
compartment and latch to secure door.
o
A repetitive beep (20 sec. intervals) indicates low
power. Battery should be charged or replaced.
o
To preserve optimum charge level remove battery
from compartment when not in use.
Charging
Installation
Low Indicator
Battery Care
ON/OFF Power
Button
Set Volume
Microphone
Placement
o
Position the microphone one finger-width distance from your
mouth. Speak into the front of the microphone, indicated by
painted arrow and “Talk”.
o
EVADE Xtreme feature four volume settings. Click UP or DOWN
buttons to adjust. Audible tone indicates low or max volume.