24
Set UP
This chapter describes the initial setup and configuration of the InSight Device and Sensor.
2.1
Positioning the InSight Device and Bed Sensing Unit
The InSight
Device should be positioned close to the patient’s bed. When an
InSight Device is
attached to the Cradle, and then is connected to the power socket, it is ready to be used. If
moving an InSight Device from another location, ensure proper connection to Cradle to allow
operation. The Sensing Unit cable should be connected to the InSight Device on the bottom.
Please make sure the Sensing Unit cable is not trailing on the floor.
Place the Bed Sensing Unit horizontally under the patient’s mattress (at least 7c
ms/3 inches thick)
and locate it underneath the chest area. Position the Sensing Unit so the top surface is facing
upwards (See Figure 5
). Ensure that the Sensing Unit’s cord is secured at the top of the bed, to
prevent tripping while patient exits the bed. If the Sensing Unit is placed on a framework which
does not allow solid support, please consult your authorized EarlySense Representative.
Figure 5: Positioning the Sensing Unit and the InSight Device
2
Summary of Contents for InSight AME-01350-US
