11
Fitting the Bonnet (32) to the Upholstery Cleaner (29)
Take the Bonnet, place it on a flat surface with the strings at the top and the
nap
facing outwards and place the Upholstery Cleaner in the middle. Pull the string
until the Bonnet fits tightly to the Upholstery Cleaner, and tie with a bow.
When cleaning upholstery you will need to glide the head across the material in
the same way as when using the Floor Cleaner. The bonnets will need to be
replaced as they become dirty. Used bonnets can be washed and re-used.
Wash at 194˚F for maximum longevity. Do not use bleach or fabric conditioner
and use only one third of normal soap powder to avoid clogging the fibres.
Spare Bonnets can be purchased from Earlex Inc or you can make your own using Terry Toweling
material.
The Upholstery Cleaner can also be used very effectively for removing the creases from hanging
drapes.
Upholstery Cleaner
/Garment Steamer
To set up your Steam Dynamo Pro as a Garment Steamer proceed as follows:-
In the Plug Storage Recess (22) there is a socket (23) to accept the button end
of the Extension Tubes. Fit the Extension Tubes together and then locate both
into this socket. Now fit the Garment Attachment Rest (30) into the top of the
Extension Tube. Your garment can now be hung from this Garment Attachment
Rest using a normal coat hanger.
Press the Steam Release Button and pass the Garment Steamer lightly across
the surface to remove creases and wrinkles from your garment.
We recommend that the unit remains on the floor and shorter garments are steam cleaned from a
seated position as shown. Longer garments can be hung from a wardrobe rail or over the top of a door.
The Garment Attachment Rest is used to “park” the Garment Steamer
safely in between steaming your garments. It can also be used to park
the Window/Tile Cleaner
Please note, the Garment Steamer is designed to refresh garments (i.e.
appearance & odour), it is not designed to be a replacement for your
steam iron. If the yellow button on the handle is pressed continuously you
may begin to see drips of water appear (this is due to the steam
condensating in the tube), by using "bursts" of steam as opposed to
"continuous" steam this will be reduced. If you should notice drips of
water from the bonnet, you should stop steaming, and wait a few seconds before drying the Bonnet
with a hand towel.
IMPORTANT – Some garments are made from very delicate materials. Always refer to the labels
in the garment, or check with the shop where the garment was bought, before applying steam.
HELPLINE NUMBER - TOLL FREE 888 STEAM 12. CALL FIRST IF YOU HAVE ANY PROBLEM
