MAINS CONNECTION
Your unit has been supplied with a mains lead and a fitted plug. This is identified by the fuse holder in the base of the plug. Please read the following
safety instructions before use.
1.
If the fitted plug is cut off from the mains lead then the plug must be disposed of safely. NEVER under any circumstances insert such a plug
into a 13 amp socket.
2
.
NEVER
under any circumstances use the appliance or mains lead without the fuse cover fitted. This is the little cover fixed into the base of plug to
hold the fuse in place.
3
. If you lose the fuse cover then please contact any electrical dealer for a replacement or ring our helpline.
4
. A replacement fuse must be rated at 13 amp. These must be manufactured and approved to BS1362.
5
.
IF IN ANY DOUBT PLEASE CONSULT AN ELECTRICIAN.
If you need to fit a plug to the mains lead, this should be fitted in accordance with the wiring instructions below, and will need to be used with a 13
amp fuse. If in doubt consult an electrician.
WARNING - THlS APPLIANCE MUST BE EARTHED.
If you are using an extension lead it must be rated at a minimum of 10 amps and fully
unwound. Do not operate with a lead rated at less than 10 amps as this will cause premature failure of the element which is not covered by the
guarantee.
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or
by the earth symbol, or coloured green or green and yellow.
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
GUARANTEE
This product is guaranteed for a period of 12 months against faulty materials and workmanship.
Whilst every possible care is taken by the manufacturer to ensure that our products leave the factory in good working order, the
manufacturer cannot under any circumstances accept liability for problems or damage caused by their subsequent use.
It is the responsibility of the user to ensure that surfaces to be treated, cleaned or stripped are suitable for steam.
This guarantee does not affect your statutory rights. This guarantee excludes the use for hire purposes.
EC Declaration of Conformity
We declare that the unit: SS125 conforms to: 73/23/EEC, BSEN60335-1, BSEN60335-2-15 & 89/336/EEC, EN55014-1,
EN55014-2, EN61000-3-2, EN61000-3-3.
Tim Hopper-Technical Director
4
© 2004
B40 12/04
