6
ALWAYS MAKE SURE THAT THE MOTOR UNIT IS ON A RIGID AND LEVEL SURFACE AND
FREE FROM DUST.
SET-UP
NEEDLE AND TIP
Needle and Tip
Best used with the following
2.5mm (in Spray Gun (Fig.1))
Medium-to-thick bodied materials for a coarse finish
• Select and fit the needle/tip you require to the spray gun (see cleaning instructions).
• Fill the Paint Container (12) with the product to be sprayed. Stir well (as mentioned previously) and
>
strain to remove any bits which may interfere with a smooth consistent spray.
• Make sure the Paint Container Seal (10) and Pick-Up Tube (11) are firmly fitted into the base of the
>
Spray Gun.
• Angle the Pick-Up Tube (11) ‘forwards’ if spraying downwards. Angle Pick-Up Tube (11) towards rear
>
of gun if spraying upwards (Fig. 3).
• Screw the Paint Container (12) to the base of the Spray Gun and tighten accordingly.
• Start with the Paint Flow Adjuster (9) at its minimum setting so the trigger cannot be pulled. Do not
>
forget that the Paint Flow Adjuster (9) controls the quantity of paint sprayed (Fig.4).
• Uncoil the Air Hose (13) and attach it to the back of the Spray Gun and the other end of the air hose
>
to the SprayStation.
• Uncoil the power cord and attach the plug to the mains supply.
• Switch the SprayStation ON. This will immediately cause some air to be produced, which is quite
>
NORMAL. However, none of the product will be sprayed until the Spray Gun trigger is pulled.
•
VERY IMPORTANT:
When spraying for the first time, we recommend you run the motor for
approximately 1 to 2 minutes before applying the product. Do not forget that the Paint Flow Adjuster
(9) controls the quantity of paint sprayed (Fig.4).
To view the ‘How to’ video please go to www.earlex.com.
OPTIONAL EXTRAS / ACCESSORIES
Needles and fluid tips of different sizes can be obtained as sets under the following accessory
numbers:
*When ordering these you MUST also order HVACV8 (Conversion Kit).
1.0mm dia Fluid Tip, Needle and Air Cap HVACV1*
1.5mm dia Fluid Tip, Needle and Air Cap HVACV15*
2mm dia Fluid Tip, Needle and Air Cap HVACV2*
2.5mm dia Fluid Tip, Needle and Air Cap HVACVP25