SETUP AND USING YOUR MaxiMist Lite
1.
Remove all contents from box.
2.
Insert hose to Turbine, you will notice that one end of the hose has small locking nibs. Insert and twist to the
right. This locks the hose into the turbine.
3.
Insert hose into Spray Gun. Push completely in with slight pressure.
4.
Fill cup with solution up to the 4 oz mark. Use NO MORE than 2 oz’s per application applied in two (2) 1 oz
coats. Follow the above “Simple Spray Gun Setup Instructions” above to properly set you spray gun up for
proper application. Turn unit on. Test the spray pattern width on a white cotton towel. Spray no more than 4
inches away, this is the same distance you will use when doing an actual application.
Keep the Turbine as far
away as possible from the spray area. The Turbine consumes large volumes of air and if to close this can cause
the Turbine to “inhale” the tanning solution overspray and can cause damage to the unit.
The ON/OFF Switch
is located on the Top of the Turbine Unit. Turn it on. You will hear a sound similar to a vacuum cleaner. You
may also notice that air is now blowing out of the front of the Spray Gun .This is correct. Air will continually
flow from the air cap of the Spray Gun as long as the Turbine Unit is running and the air hose is connected.
5.
Make swift vertical or horizontal movements (dependant on the direction of the Air cap part #2) over the
body. KEEP THE SPRAY GUN IN AN UPRIGHT POSITION, DO NOT ROCK OT TIP!!!!!
Proper spraying technique
6.
Do not overlap a just applied part of the body; you need to give the solution time to absorb into the skin.
Doing so will cause drips and runs or beading on the skin.
7.
Do 1 (one) full body coverage, then start back at the beginning and apply the second coat.
8.
After you have applied the second coat, stand in front of a fan until dry, should take no more than a few
minutes unless you have over applied the product. REMBER, never more than 2 oz’s per full body application.
9.
You can shower in as little as 4 hours, for best results wait 8-12 hours.
10.
After you are done with your MaxiMist Lite for the day, simply put some tap water into the cup and spray
until clear to rinse out any tanning solution residue.
11.
On occasion, check the Turbine Air Filter (part# 15), if it appears dirty or saturated, simply rinse out and
replace.
