ATTENTION! Before cleaning or performing any maintenance on the heat
gun, disconnect from the power supply.
10.1 MAINTENANCE
Your heat gun has been designed to operate over a long period of time with minimal
>>
maintenance. Continuous satisfactory operation depends upon proper tool care and
>>
regular cleaning.
10.2 LUBRICATION
Your heat gun requires no additional lubrication.
10.3 CLEANING
Keep the ventilation slots clean and free from dust and dirt to prevent overheating.
Regularly clean the gun housing with a soft cloth, preferably after each use.
>>
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
11. TECHNICAL DATA
Power Supply
120V 60Hz
Max Output
1500w
Air Temperature / Flow
9
9.4 STATIONARY USE
This tool can also be used in stationary mode.
Place the tool onto the work bench with the gun nozzle
①
facing upwards.
Secure the power cord to prevent pulling the tool off the workbench.
Switch the tool on using the control switch
③
and set to position 2.
9.5 COOLING DOWN
The nozzle and accessory become very hot during use. Let these cool down before
attempting to move or store the tool.
To reduce cooling time set control switch
③
to position 1 - “cool down mode” and allow to
>>
run for 30 minutes.
Switch the control switch
③
to position 0 and ensure heat gun in cool before moving or
>>
storing.
10 MAINTENANCE AND CLEANING
1) 120ºF;
250-500L/min
2) 120-1200ºF
250-500L/min
12. TROUBLESHOOTING
If a problem occurs, immediately switch off or unplug the unit at the power supply.
All manuals and user guides at all-guides.com
