Press #1key once Arm/Doors Lock
Press #1key once after set arming 1st stage - sensor bypass
Press #1key twice after set arming 2nd stage -sensor bypass
Press #1key once after set armed 10sec. Car finder mode
Press #2key once Disarm/Door Unlock
Press #2key once after set disarming 2nd door(s) unlock
Press #2key for 2sec. Trunk release
Press #3key once Silent Arm
Press #4key for 2sec. Panic mode
Press #4key for 2sec. In Acc on Anti-car jack mode.
H o p p i n g c o d e r e m o t e f u n c t i o n
STANDARD FEATURES:
To ARM the system:
To arm your system within proper operation range, simply press button #1(while system in
disarm position) . The system will respond one siren chirp, one lights flash, doors lock, disable engine starter, LED will begin
flashing slowly.
SILENT ARM:
Press button #3 in disarm position to enter silent arm. Lights will flash once doors locked and engine
disable. The system will effectively arm silently and remain in this mode for disarming.
DEFECTIVE ZONE BYPASS:
If armed, the system responds with 4 siren chirps, it indicating that one of the zone is not
close properly. The dash mounted LED will flash different times to identify. ( Flash 4times: hood/trunk not closed /
5times: door's not closed) The system will bypass that zone and still protect other zones.
AUTO RESET:
If a violation occurs the system will respond by sounding the siren and flashing the lights for approximately
30sec. before the system resets itself and continues to protect your car. If violation still occurs the system, siren and lights
will working for 6 cycles then the system reset itself and continues to protect other zones.
To DISARM the system :
To disarm your system within proper operating range, simply press button #2. The
system will respond two siren chirp, two light flash, doors unlock, Enable your engine starter, LED off .
INTRUSION ALERT:
Upon disarming the system, if the vehicle is attempted or intruded, siren and lights will
indicates 4 chirps and 5 flashes to identify which zone was triggered. LED mode indicates the following different triggering.
Quick flash 2 times after a pause Sensor 1st stage triggered
Quick flash 3 times after a pause Sensor 2nd stage triggered
Quick flash 4 times after a pause Door opened
Quick flash 5 times after a pause Hood/Trunk lid opened
Quick flash 6 times after a pause Ignition switch triggered
Automatic REARM:
If the system is disarmed by remote and a door is not opened within approximately 30 sec.
the system will automatically rearm itself. This feature guards against disarming caused by accidental or unintended
operation of the remote transmitter.
Car Finder:
If your car in crowded big parking place ,you can easy to find your car position by press button #1 once
after you set armed 10sec. you will hear one long sound and followed with 30sec. lights flashing .
Remote SENSOR BYPASS:
The system offer 2stage sensor optional. Within 10sec. After set arming, to press
#1key once, siren will chirp twice, then 1st stage sensor bypassed. To press button twice , siren will chirp 3 times then all
sensors will be shut off and no sensor working for arming protection.
PANIC mode:
If you are threatened in or near your vehicle, you can attract attention by triggering the system with
your Remote. Just press #4key for 2sec., and you will enter Panic mode. The siren will sounding ,parking lights will flashing
, engine disable and pager will constant output for 30sec. To stop Panic mode at any time, simply press button #2.
Remote TRUNK RELEASE:
This channel is a negative (-) output features. (Car starter, trunk release, window
roll-up, etc.) See your dealer for details. To activate this channel by Pressing and hold button #2 for 2seconds.
DUAL STAGE SHOCK SENSOR:
If alarm armed, light touch will cause 1st stage sensor activate siren will
chirp once . Heavy impact will cause 2nd stage sensor activate, siren and lights will working for 30 seconds.
NOTE
: Adjustments are made via the rotary control above the shock sensor.
VALET MODE:
If you are going to have your vehicle serviced, parked by a valet or washed you will want to put your
security system into valet mode. To enter valet mode disarm the system and turn Ignition to ON. (1)pressing button #1 + #2
simultaneously for 2sec. (2)Press valet switch for over 5sec. Lights will flash 3 times and LED will light ON to confirm enter
valet mode. When the system is in the valet mode it can not be armed. The door lock and unlock will function as keyless
entry system.
To EXIT:
Turn Ignition ON, pressing button #1 + #2 simultaneously for 2 seconds. Or press valet switch for over 5sec.
You will hear 3 chirps and LED light OFF to confirm exit this mode and in alarm mode.
