Operating Manual / en
eMG
page 18 / 26
Rev. 2
05/02/2020
Possible installation order:
Installation of the seat:
Feed the
degreased
sealing element (o-ring, rubber cup) onto the seat.
If available:
Mark the position of the rear slot at the seat, namely at the front side beside the
sliding face.
Align the seat with the torque transmission pin.
Cover the sliding face of the seat with a cardboard washer.
Press the seat slowly and without interruption into its position.
Use plenty of low-surface-tension water or ethyl alcohol as lubricant.
If necessary, use an assembling aid.
Remove the cardboard washer from the sliding face.
Check the rectangular position of the seat.
If available:
Install the axial seat lock.
