BEFORE USE
Inspect the product including its cable and plug for any signs of damage. If the product is damaged, DO NOT use
it, and contact your supplier immediately.
PRODUCT SAFETY
Keep away from children.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children.
Do not use in close proximity to gas appliances
Do not cover when in use.
Do not place the mains lead beneath a carpet or rug.
Do not use the product in locations where paint, petrol or other flammable liquids or gases are used or
stored. Risk of fire and explosion..
Do not use this appliance in the immediate surroundings of a bath, a shower or a swimming pool. Risk of
Electric Shock.
The product must be positioned on firm level surface and away from any obstructions.
This unit is for indoor use only.
Do not touch the iron tip and shaft. Hold by the plastic handle only. Very hot. Risk of burning.
This product generates heat up to 480 Deg C. Improper use may lead to a risk of fire and burning
Do not leave this product unattended when switched on.
Only use this product in well ventilated areas. Soldering produces fumes. Risk of breathing issues.
Disconnect from the mains when not being used.
Do not attempt to replace the tip when hot. Allow the product to cool down. Risk of burning
There are no user serviceable parts in this unit other than the tip.
Inspect the product for damage before use.
OPERATION AND FUNCTIONS
1) Fuse holder (rear) Use 1 A MGP fuse only
2) Temperature Display
3) Heat Resistant Silicone Cable
4) Handle
5) Collar
6) Heater with sensor
7) Tip
8) Knurled nut barrel assembly
9) Power Switch
10) Temperature adjustment
11) Tip cleaning sponge
12) Iron Holder
After following the safety instructions above plug the unit in
and switch on.
With the display switch on “SET” use the temperature
control knob to select the required tip temperature.
Turn the display switch t
o “read” and the Led read out will
show the actual temperature of the tip. This will change
until the tip reaches the set temperature.
