Sliding Doors
1. Unlock and open the door panel.
2. Locate the battery tray above the keeper on the
door jamb.
3. Using a small needle nose pliers, grip the center of
the battery tray to remove from the sensor cover
plate.
4. Remove the discharged batteries (see battery
disposal information on page 5).
5. Replace the batteries with two fresh CR-1632
lithium coin cell batteries. Take care to properly
position the “+” terminals of both batteries to
correspond with the “+” marking on the battery
tray for proper battery polarity.
6. Insert the battery tray back into the sensor cover
plate. The tray may encounter light resistance
during insertion. Continue until the outside edge
of the battery tray is flush with the plate.
7. Close and lock the door unit.
8. Verify that the sensor is communicating with the
security control panel by unlocking the door and
checking the keypad for the door unlock message
and then opening the door and checking the
keypad for the door open message. See page 4
for verification instructions.
Battery Replacement Instructions - continued
Finishing and General Care
Finishing
•
Read and follow the care and maintenance
instructions for you Eagle
®
windows and doors
available online at EagleWindow.com.
•
Mask the hardware to make sure that no paint and
finishing products are allowed to come in contact
with the hardware during the finishing processes.
If you need to remove the lock bezel and lock lever
from casement or awning windows, insert a
protective mask over the bezel opening to protect
the sensor.
In lieu of removing double-hung hardware during
the finishing process, simply mask the sash lock
assemblies with painter’s tape to protect them and
the sensor. Also mask off the locking
mechanisms on the outside edge of the sash.
Sliding Doors
Door
Jamb
Sensor
Cover
Plate
Battery
Tray
Interior View
Keeper
Battery
Tray
Small
Needle Nose Pliers
Hinged door center strike plates can be easily
masked with painter’s tape to protect the center
strike plate and sensor. Carefully set any removed
hardware aside.
The sliding door keeper and sensor cover plate is
easily masked with painter’s tape to protect all
components.
When applying casing on the strike jamb side of
doors, make sure fasterners are located above and
below the strike or keeper, so as not to damage the
security components.
User’s Guide
10