1. Attach support shelf brackets to support shelf, using acorn nuts,
washers, bolts and predrilled holes.
Note: acorn nuts must be at the top.
2. Install 10-32 x 3/4˝ screws into threaded fasteners on hot food
table. Do not tighten.
3. Align keyholes in mounting brackets with screws and mount
support shelf/bracket assembly to table. Tighten screws.
4. Hook metal plate shelf into bottom flange of plate shelf brackets.
5. Using keyholes on support shelf brackets, mount plate
shelf/bracket assembly onto support shelf/bracket assembly.
6. Align holes in cutting board with acorn nuts, and place cutting
board onto support shelf.
ASSEMBLY INSTRUCTIONS
Electric Hot Food Table with
Sealed-in Wells (SHT Series)
AdjustableUndershelf
CuttingBoardandPlateShelf
1. Place table upside down with gussets facing up.
Caution - use cardboard or other material to
prevent scratching top.
2. Install legs into gussets. Make sure rivet in leg is closer to
gusset than to the foot end.
3. Align undershelf gussets with legs and slide undershelf down
legs to desired position. Recommended height is 10˝.
4. Tighten set screws in undershelf gussets and install foot into
each leg using a rubber mallet.
5. Tighten set screws in table gussets.
6. Place table upright.
SUPPORT
SHELF
BRACKET
PLATE SHELF
BRACKET
WASHER
HEX BOLT
ACORN NUT
10-32 X 3/4˝
SCREWS
STAINL
ESS ST
EEL SU
PPORT
SHELF
METAL
PLATE S
HELF
CUTTIN
G BOAR
D
NOTE: Legs and undershelf must be
assembled BEFORE securing legs to table.
(continued on back page)
