CONGRATULATIONS ON YOUR PURCHASE
Thank you for purchasing this Eagle Tape Light Kit. Please read these instructions carefully
and leave with the user of the product for future reference. If the product is sold on, then the
instruction/manual should pass on as well.
BEFORE USE
You must inspect the product and all accessories including any cables and power supply for
any signs of damage. If the product is damaged, DO NOT use it, and contact your supplier
immediately.
PRODUCT SAFETY
• Children shall not play with the unit.
• Do not place the mains lead beneath a carpet or a rug.
• Cleaning and user maintenance shall not be made by children without supervision.
• Please ensure the power supply is switched off when not in use.
• Do not leave this device switched on when unattended.
• Though the tape light section of this product is IP rated any connections and its power supply
are not and must be kept dry.
• Periodically check this product and its power supply for damage. If any is detected do not use
and contact your supplier.
• The power supply MUST be kept in a well-ventilated area away from sources of heat and
moisture, such as a cooker and kettles.
• Never operate the light when fully wound as this may cause overheating.
INCLUDED IN THE BOX
1 x 5m Tape Light
1 x 12V 2A In-line power supply
OPERATION
• Installation must take place whilst the unit is unplugged
• The product MUST NOT be mounted using staples, nails, or metal fixings.
• The product can be cut at 5cm (3 LED) intervals to the required length, highlighted by a line
straddled with a pair of scissors. This cut can be made with regular scissors (not supplied).
• The product can be installed in the desired location simply by removing the self-adhesive
backing on the rear of the tape light and pressing the tape light against a smooth clean surface.
The surface must be free of dust and grease.
• Apply firm pressure along the length of the tape light to ensure it has adhered in all locations.
• Once installed, plug the product in and switch the mains power on.
MAINTENANCE
There are no user serviceable parts in this product. Periodically check the product for LED failure
and damage. If any of the LED’s have failed or the product is damaged in anyway switch off
and disconnect from the mains supply. To clean the product, switch off and disconnect from the
mains supply. Using a slightly damp cloth gently wipe over. Do not use bleach, solvent based
cleaners or strong detergents. These may damage the product and invalidate the warranty. If
the mains lead is damaged, it must be replaced by the manufacturer or and authorised service
centre.
