Eagle FishEasy 350c, Installation & Operation Instructions

Page: 23 / 168

21
water flow to the speed sensor. Make sure the sensor will remain in the
water when the boat is on plane. Also make sure the location doesn't inter-
fere with the boat's trailer. Typically, the sensor is mounted about one foot
to the side of the transom's centerline.
2. Place the sensor on the transom. The bottom of the bracket should be
flush with the hull's bottom. Using the sensor as a template, mark the
hull for the screws' pilot holes. Drill four 1/8" holes, one in each end of
the slots.
3. Mount the sensor to the hull using #8 stainless steel wood screws
(not included). Use a
high quality, marine grade above- or below-
waterline caulking compound to seal the screws. Make sure the sensor is
flush with the bottom of the hull and tighten the screws.
Stern view showing good location for mounting sensor on transom.
Speed sensor mounting configuration:
side view (left) and rear view (right).
Good location
Transom
Bottom of hull
Bottom of hull