5
Wear hearing protection.
Wear eye protection.
Wear respiratory protection.
Read the instruction manual
BEFORE USING THIS AIR TOOL
OPERATING INSTRUCTIONS
To set the tool to desired torque, select a nut or screw of known tightness of the same size,
thread, pitch and thread condition as those on the job. Turn air regulator to low position,
apply wrench to nut and gradually increase power until nut moves slightly in the direction
it was originally set. For additional power needed on disassembly work, turn regulator to
its fully open position. This impact wrench is rated for ¾” bolts. Do not use impact wrench
beyond rated capacity as this will drastically reduce tool life.
To ensure long life be sure to oil the tool daily. Pour 4 drops of Eagle air tool (SEA 20 non
detergent) oil into the air inlet, and then run the tool for a few seconds to clean.
If tool is an impact wrench fitted with a “Zirc” grease fitting:
The hammer mechanism of this tool also needs to be greased from time to time (depending
on usage). The tool is equipped with grease fitting for this purpose; use this connection to
re-grease the tool using Eagle impact wrench grease.
PLEASE USE EAGLE SEA 20 NON DETERGENT OIL
TROUBLESHOOTING
SYMPTOMS
CAUSE
REMEDY
Air tool does not
run or runs slow.
Lack of lubrication.
Lubricate as per instructions.
Dirt in tool.
Clean with mixture of 50/50 tool
oil/solvent. Lubricate after cleaning.
Insufficient air pressure.
Check regulator and air supply for
leaks. Check compressor to make
sure it operates at correct pressure.
Make sure air hose is properly sized
and that multiple hoses are not
connected to same outlet. Check air
hose for leaks and repair.
Rotor blades worn or motor
bearing worn or dirty.
Replace blades, inspect clean or
replace bearing.
IMPACT WRENCH
does not impact or
impacts slowly.
See causes (above).
See remedies (above).
Broken or worn impact
mechanism.
Inspect and repair as required.
