Eagle 710, Operation Manual, Page: 20 / 167

- 20 -
4. Machine Operation
4.1 Heater Warm Up
After switching on the strapping machine, the heater will begin to heat. The LCD display will remain on
until the heater reaches operating temperature (approximately 2 minutes).
Machine will not operate until heater reaches operating temperature. The heater fans will run during
initial heating cycle.
4.2 Strap Tension Setting
The strap tension setting change be changed by adjusting the tension setting
knob. Turning the knob to the right will increase tension and turning the knob
to the left will decrease tension.
4.3 Function Encoder
The LCD display can be used to show various timers such as cooling time, timer 1, timer 2, etc… After
pressing the function encoder knob for 2 seconds, turn the knob to select the timer to be changed.
Select a timer by pressing the knob while the timer name is displayed on the LCD screen. After
selecting a specific timer, the value can be changed by turning the knob and then set by pressing the
knob.
Main Power Switch
to Position 1
Heater warms up and
LCD display is lit
Ready to Operate
LCD display turns off
Ready
<- Timer
TEC
<-
<- T5: 0-60
000
<- T5: 0-60
000
<- T5: 0-60
010
<- Timer
TEC
Ready
Press encoder knob
for 2 seconds
Select timer and
press encoder knob
Turn encoder knob
clockwise
Turn knob, select by
pressing knob
Turn knob, set value
by pressing knob
Turn knob counter-
clockwise to <- and
press knob to exit
Turn knob counter-
clockwise to <- and
press knob to exit