Lowering the Jack
1. Raise load high enough to allow clearance for the jack stands to be removed, then
carefully remove jack stands.
2. Remove support stands.
3. Grasp the handle firmly with both hands. Securely hold on to the jack handle so your
hands do not slip and ensure the release valve does not rapidly lower.
4. Carefully open the Release Valve by slowly turning the handle counter-clockwise. (Do
not allow bystanders around the jack or under the load when lowering the jack.
5. After removing jack from under the load, keep jack in the lowered position to reduce
exposure to rust and contamination.
NOTE: Always store jack in the fully lowered position, and the handle in the upright position.
To Add Jack Oil
1. Position the jack on level ground and
4.Fill the oil case until oil level is just
beneath the lower rim of the oil fill hole.
lower the saddle.
2. Remove cover plate.
3. Remove the oil plug.
6.Replace coverplate and perform the Air
Purge Procedure.
5. Replace oil plug.
Cover plate
Cover plate
www.eagleprojacks.net
