FORM DHS2 EAGLE POWER PRODUCTS FLOOR EXTRACTOR (10-25-02) - 11
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
REMEDY
Will not heat
Water level too low.
Fill water to top edge of lid ring.
(but vacuum comes on).
No solution from
Nozzle tip plugged.
Disassemble and clean.
spray nozzle tip.
Check quick-disconnect fitting.
Reconnect fitting onto machine.
Solution tank empty.
Refill to absolute top of lid ring.
Pump failed.
Replacement required.
Kinked solution hose.
Straighten hose.
Poor water pickup.
Vacuum hose cuff is not
Push hose cuff onto fitting.
firmly pushed onto
Check for cracks in hose.
recovery tank fitting.
Vacuum motor intake
Remove and clean filter.
filter is clogged.
Vacuum gasket between tanks
Replace gasket.
is worn or damaged.
Recovery tank lid not sealing.
Replace or tighten lid.
DEFECTIVE MACHINE!
Unplug immediately and call factory
DO NOT ATTEMPT TO REPAIR!
Service Center or the point of purchase.
Left exposed in freezing conditions.
Refer to Service Center.
Defective pump seal.
Replace pump.
Overheats and
Float level switch in solution tank
Replace float switch.
and boils water.
may be damaged.
Thermostat Failure.
Replace thermostat.
Plugged into outlet,
Overloaded circuit breaker.
Circuit breaker reset.
nothing comes on.
Unplug other electrical items
on same circuit.
