●
This manual is only for reference and does not
ensure that the information is totally consistent
with the actual product. For consistency, see the
actual product.
1. Package Contents
Open the package, check the appearance of the
product for no obvious damage, and confirm the
item list for table 1-1 is consistent.
Table 1-1: Packing List
Component
Quantity
Vandal Dome Network Camera
1
Setup & Support Insert
1
Installation Location Sticker
1
L Hexagonal Wrench 80×25mm
1
Stainless Self-Tapping Screw
PA4.0×30mm
3
Swell Plastic Button
φ5.6×29mm
3
Auxiliary Thread-Line Tool
1
Green Terminal Block 3.81-9P
1
Green Terminal Block 3.81-4P
1
2. Device Structure
Camera Dimensions
Note: Different devices may have different dimensions;
please refer to the actual product.
Figure 2-1: Dimensions of Dome (Units: mm)
3. Device Installation
Warning: To avoid moisture influence, install
the dome cover at least half an hour after the
camera is installed and powered on.
The Vandal Dome Network Camera can be
installed on the ceiling or wall. This guide
describes how to install the camera on the
ceiling.
Installation Steps
1. Use the wrench in the accessory package to
unscrew the three screws on the dome cover.
Open the camera, as shown in figure 3-1, and
remove the base panel.
Figure 3-1: Opening Camera
2. Attach the installation sticker to the ceiling.
Drill three holes as indicated by the sticker.
Drive the swell buttons into the holes, as
shown in figure 3-2.
Figure 3-2: Driving Swell Buttons
3. Use the three self-tapping screws to fasten
the base panel of the camera to the ceiling,
as shown in figure 3-3. Pay careful attention
to the position of the hook, as it should pass
the bump as shown in figure 3-3.