GARAGE
MOTOR
1.
12
13
2.
1.
Putthewiresof thegateopener intotheirplaces(connector)
The outputs of the device are dry contact relay outputs. The inputs can only be driven by
dry contactoutputs.
Each output and input reserves2 pinsin the connector of the device.Regarding the pinout
of deviceplease checkthe wiringdiagramon pages 10-11.
The operation mode of the relay outputs can be configured in the application. Momentary
pulsemode with adjustable pulselengthor static on/off mode can be chosen.
NOTE:
Most of the garage door/gate openers are compatible with the pulse mode only
therefore it might be harmful for these devices to be used with on/off mode.Avoid switching
to static on/off mode unlessyou knowwhatyou are doing.
2.
Plugtheconnector intotheNoldOpendevice
The Nold Open must be connected to the appropriate points according to the connection
drawing,with the control panel de-energized.
3.
Fasten the wires with ascrewdriver
4.
Mount NoldOpenonthewallwith2screws.
The device should be installed as close as possible to the entry zone and as far as possible
from metallic elements as they negatively affect the transmission distance of Bluetooth
®
signals. The device can be used both indoors and outdoors. In case of outdoor use, the
device must be fitted below a weatherproof protective cover. The device should be installed
at a heightof at least 1.5 metres above ground level.
For further information please visit
nold.io/help
