3660-MANUL-V01.01.00-CDC3 Operating Manual
Page 18 of 30
This will populate the drop-down list under Channel 1, with the selected options. From this drop-down list,
then select the appropriate option for the phase being tested and click OK, as shown in Figure 33.
Figure 33
Setting phase for single-phase measurement
For a three-phase measurement, the phase naming convention must be set in the same way. All three drop-
down lists for the channels will now be activated, and each drop-down list must have an option selected. The
drop-down list for channel 3 is shown in Figure 34.
Figure 34
Setting phase for three-phase measurement
Once the phase for each channel has been set, click OK. Note, it is not possible to select the same phase
label for multiple channels.
