3660-MANUL-V01.01.00-CDC3 Operating Manual
Page 16 of 30
4.3.4
Voltage
The next field, visible in Figure 28, is the Voltage of the cable under test. Several common voltages for the
UK distribution network are available by default.
Figure 28
Voltage drop-down selection
If the cable under test operates at an unlisted voltage, it is possible to add further options. To do this, select the
Other…
option at the bottom of the list. The window, shown in Figure 29 will then be displayed, which will allow
you to enter a new voltage. Only the numeric value of the voltage needs adding, as the software automatically
adds the CDC. With the new value entered, click Add.
Figure 29
Voltage Entry
4.3.5
Switch Position
The Switch Position option is to enter the status of any switch that may be present on the cable at the point of
measurement. If there is no switch present, then Absent should be selected. The Open option would be for
cases when the switch is open, and the cable is energised but with no load. The Closed option is for when the
switch is closed, and the cable is energised and carrying a load. It is only possible to perform testing on
energised cables. The options are shown in Figure 30.
Figure 30
Switch position selection