© 2005 GLOBAL VR
Page 3 of 7
040-0084-01 8/8/2005
Installing the Players' Card Dispenser
10. Depending on your computer, you may need to remove the power supply to access the DB25
mounting hole, as shown in Figure 2. To remove the power supply, remove the four mounting
screws that are circled in the first part of the picture below.
Note:
If you prefer, you can purchase a DB25 PC blanking plate, such as PLATE925 from
StarTech.com, that will allow you to mount the connector in an unused PCI card bay.
Figure 2. Installing the DB25 Connector on PC Rear
11. Secure the DB25 connector in the mounting hole using the two screws from the kit, as shown
in the second part of Figure 2.
12. Replace the power supply, if you removed it, and secure it with the four screws.
13. Replace the side panel on the computer and secure it with the two screws.
14. Please return the leftover USBI/O card to GLOBAL VR
®
in the packaging used for the
USBI/O card in the kit. A pre-paid mailing label is included for US customers.
Install the Players' Card Dispenser Assembly on the Cabinet
1. Disconnect
the
cabinet from AC power.
2. Determine where you want to mount the Players' Card dispenser. The dispenser can be
mounted to either side or the front of the cabinet.
WARNING: Follow all safety precautions while drilling the cabinet. Wear safety
glasses and follow safety guidelines. Be careful to avoid drilling into cables or
components.
3. Position the card dispenser on the cabinet. Open the door and mark the locations for the
mounting bolts and harness hole.
4. Inspect the inside of the cabinet before drilling to make sure that you will not damage any
harnesses or other components.
5. Drill four (4) 1/4" holes for the mounting bolts in the locations that you marked.
6. Drill a 3/4" hole for the harness in the location that you marked.
7. Install the button plugs from the kit in the harness holes on the exposed sides of the dispenser.
8. Secure the card dispenser assembly to the cabinet with the four (4) bolts, washers, and nuts.
