E2S Warning Signals
Impress House, Mansell Road, Acton, London W3 7QH
www.e2s.com
Tel: +44 (0)208 743 8880
Document No. D199-00-621-IS
Issue 2
27-10-22
Sheet 10 of 15
14) SIL 2 Wiring Configuration and Beacon Set-Up
Figure 12: Terminals and header pins for beacon.
Power & Communication with the system control panel can be configured in two ways: - Although it is
highly
recommended that the
unit is wired as stated in section 15-1 as a 4-Wire System.
J1 Header
–
Current Sense Resistor (CSR)
Shown in factory default position A
(see section 15-3), places TB1 Current
sense resistor in circuit
J2 Header
–
Fault Resistor (FR)
Shown in factory default position A
(see section 15-3) removes power
supply terminal block. Fault resistor
& relay RLY 1-1out of circuit.
J7 Header
–
Hard Reset
Shown in factory default position A
(see section 15-4), set to
Normal operation
+
Beacon Supply Terminals
+
-
-
1
2
SIL Relay Terminals TB1
3
