Page8
Fuse Installation
Your scooter comes with a 20amp fuse that is NOT installed at the factory.
Follow the instructions below to properly install the fuse before attempting to use your
scooter.
1. Locate the 20amp glass fuse that came with your scooter.
2. Locate the fuse holder on the right side of the scooter frame under the footplate.
(Fig.5)
3. Remove the fuse holder cap and insert the fuse into the cap first.
4. Then insert fuse/cap into fuse holder and gently tighten. DO NOT OVER
TIGHTEN THE CAP.
Seat and Seat Post Installation
1. Insert the seat post into the bottom of the seat and tighten securely.
2. Next, insert the seat post into the post receiver that is already attached to the
footplate on the scooter and tighten the clamp securely.
Charging
Your scooter comes charged out of the carton. We still recommend charging the unit for
6-8 hours prior to it’s first use. We also recommend charging your scooter after each use
and prior to storage.
WARNING:
Do not
allow your scooter to go into deep discharge, as this will damage the
batteries.
Fig. 5
Fig. 6
1. Make sure unit is turned off.
2. Open the charging socket cover
located on the right side of the
scooter frame, under the footplate.
(Fig. 5)
3. Locate your Battery Charger. (Fig.
6) Find the charger socket end
that has a three-prong socket and
plug it into the scooter.
4. Next, plug the AC plug into a wall
outlet.
When first plugged in, the charger has two
red lights that will illuminate at the same
time, indicating that the charging process
has started. Once the light on the charger
turns green, you may remove the charger
and close the safety cap.
