8-13
8
7. Add the specified amount of the recommend-
engine oil filler cap.
Tightening torque:
Engine oil drain bolt:
8 Nm (0.8m·kgf, 5.8 ft·lbf)
Recommended oil:
See page 10-2.
Oil quantity:
0.75 L (0.80 US qt) (0.66 Imp.qt)
NOTICE
Do not mix any chemical additives. Do not
use oils with a diesel specification of "CD"
or oils of a higher quality than specified.
In addition, do not use oils labeled "ENERGY
CONSERVING II" or higher.
the crankcase.
8. Start the engine,check oil lubrication by oil
Make sure that no foreign material enters
check bolt, and then let it idle for several min-
utes while checking it for oil leakage. If oil is
leaking, immediately turn the engine off and
check for the cause.
9. Turn the engine off, wait at least ten minutes,
and then check the oil level and correct it if
necessary.
4. Remove the engine oil filler cap, and then
remove the engine oil drain bolt to drain the
oil from the crankcase.
5. Check the washer for damage and replace it if
necessary.
6. Install the engine oil drain bolt, and then tighten
it to the specified torque.
1
2
3
4
1. Engine oil drain bolt
2. O-ring
3. Spring
4. Oil filter element
ed engine oil, and then install and tighten the
www.Get2itParts.com
www.Get2itParts.com
www.Get2itParts.com
