Right Handlebar Control
Head Light Control Switch
For safety, the head light system of this unit
was designed to be illuminated at all times
while the unit is running. The intensity of the
light is changed by using the head light
control switch located on the right-hand
handlebar. It is a three position slide switch.
Far right position sets beam intensity to 20%
(Day Time Running), middle position sets
beam intensity to 80% (Low Beam), and far
left position sets beam intensity to 100%
(High Beam).
The vehicle is equipped with a PTC controller
that will dim the lights to the 20% position
automatically if the engine RPM falls below
the pre-set threshold for more than a minute.
Increasing the engine RPM will return the
light to the normal level for the control switch
selection.
Control feature operations
The stop switch is a red colored rocker switch
located on the left-hand handlebar.
To start and run the engine, this switch must be
placed in the on, position.
The vehicle is also equipped with a safety brake
switch which will prevent the engine from starting
until the parking brake is engaged.
To stop your engine, place the switch to the stop,
position
In the stop, position the ignition system is
grounded preventing the spark plug from firing.
This switch can also be used as a safety or
emergency stop switch.
The turning signal switch is a three position
switch located on the left-hand handlebar. Sliding
the switch in the direction of the intended turn will
illuminate the front and rear turn signal lamps in a
blinking mode. Pressing the white button, on the
center of the switch, will return the switch to the
neutral position and cancel the illumination of the
turning lamps.
Horn Button
The horn button is a yellow push switch,
located below the turning signal lamp switch
on the left-hand handlebar. Pressing in on
the button will sound the audible horn signal.
Releasing the button will silence the horn.
Turn Signal Switch
Engine Stop Switch
Left Handlebar Controls
Page 4
Head Light Control
Starter Motor Switch
Manual choke lever
This choke is operated by the lever at the bottom
of the left hand control switch.
When first starting the engine,(cold start), place
the lever in the full left position, (Choke closed
or on) As the engine warms return the lever to
the full right position. (Choke open or off).
Copyright ©2008-2009 ETON America, all rights reserved.
