21
Boot up the E-Pos Magnum and press "DEL" key to enter CMOS
Bios Setup screen, Select "Frequency/Voltage Control" CPU
Host/SDRAM/PCI Clock: Default Press Enter to change For
example: if your CPU and SDRAM external frequency is 133Mhz
Then set it as 133/133/33 (Our PCI Clock is 33 MHz)
After set CPU & SDRAM & PCI Clock Save & Exit Setup Reboot
and check boot up screen, then you will see correct CPU type and
frequency.
Q7. What command do I use to open the Cash Drawer through the
Printer using a). Star Emulation or b). Epson (esc/pos) Emulation?
A7. a). chr(28)
b). chr(27)+chr(112)+chr(0)+chr(50)+chr(250)
Q8. Why use the Purple Ribbon?
A8. Quite simply the dye based purple ribbon has a longer life; i.e. can
print more characters, than the pigment based black ink. However
the advantage of using black ink is that it has more impact and is
therefore more visible.
Q9. Why does my Printer print Question Marks at the Beginning of a
Print Run?
A9. Printers communicate via either serial or parallel ports. All serial
printers use DIPswitches to configure the various serial
communication parameters. The serial communication parameters
set on the printer must match those set on the computer in order for
their communication to be successful. When the serial parameters
on the printer do not match those on the computer the printer will
illustrate this by printing questions marks whenever a print-job is
Initiated. The problem can be corrected by matching the serial
parameters as set on the printer to those set on the computer to
which it is connected. By default all Star serial printers are
configured at 9600 BAUD, 8 Data-Bits, No Parity, and 1 Stop-Bit.
