17.
SOLUTION CHART
INCIDENCES
POSSIBLE CAUSA
SOLUTION
1. The charger is not connected
properly.
1. Adjust the connections to ensure good contact.
Ensure that the battery is in the right position
(ONOFF). Verify the plug.
2. The charger does not work well.
2. Check the charger light to be on. Contact to the
technical service in case it did not blink.
3. The fuse is out.
3. The fuse must be changed.
1. The battery is discharged on the
whole.
1. Check the battery indicator and recharge if it
were necessary.
2. The fuse is shorted out or not
connected properly.
2. Check the fuse and replace if faulty (see the
technical service section)
3. The key switch does not work.
3. Verify the connections and contact technical
service if faulty.
1. The cable has been detached from
the battery.
1. Check to ensure that the battery is connected
properly.
2. The fuse is fused.
2. Check the fuse and change it if it were
necessary ( see technical section)
1. Engine overheated
1. Intensive and continuous use of the bike at
maximum power may overheat the engine and its
controller. In this case, wait a few minutes to let
2. The fuse is fused
2. Check the fuse. See the relevant section.
3. The battery is discharged.
3. Check the battery charge. The amount
consumed may be different depending on the
4. There is an electric malfunction.
4. Check the electric connections. See the
relevant section.
1. The battery has not been charged
properly.
1. The battery has to be in top conditions to
achieve the full charge autonomy established in
this manual. You also have to consider that the
distance you ride will vary depending on the
rider’s weight, the trajectory or STAND UP
conditions.
2. The battery is not recharging
correctly.
2. Contact to a technical service.
1. The wheel is not aligned properly.
1. Check the alignment of the wheel .
2. The spokes can be loose.
2. Tight the spokes
3. The engine gears are worn.
3. The bearings in models without brushless
engine may wear out. In this case, contact an
authorised dealer to replace them.
1. the bike is still brand new. It needs a
little running.
1. It is normal in a new bike for brakes to make
some noise. If after a few days of use the, noise
persists, check the brakes to be aligned.
2. The brakes are not aligned.
2. Place the brakes in the right position (see the
relevant section)
3. The brake levers can not be tightened
properly.
3. Check the lever tension by means of a
regulator.
4. The brake shoes are worn.
4. Check the brake pads and replace them it were
necessary.
3º The engine suddenly stops after
moving just a few meters or when
climbing a not very steep hill.
2º When turning the battery key, the
charge indicator does not light up.
6º A strange noise can be hear for the
front wheel (engine)
1º Alter setting the battery to charge, it
looks like it did not charge.
7º The brakes make noise or/ they do not
brake very well.
5º The battery has not enough autonomy.
4º The engine stops or works irregularly
after having use the vehicle continuously
or on uphill climbs.
Summary of Contents for STAND UP
Page 1: ......
Page 57: ...2 PARTIES DU STAND UP ...
