BackPack User Guide | 5
Assembly Instructions and Tips
1. Rechargeable Battery: The system uses up to two
lithium-ion batteries. Tips:
a. The battery should be fully charged prior to the
start of a project.
b. Inspect the connectors for any debris or damage
prior to inserting.
c. The tab end of the battery includes a power meter
to show remaining charge (5 bars = full charge).
d. Two bars or less during startup may limit time of
use without charging.
e. The connector side of the battery enters the Back-
Pack case.
f. Keep battery handle tab to the left as you insert.
g. DO NOT OVER APPLY PRESSURE – The battery easily
seats in the BackPack. Over applying pressure may
make the battery difficult to remove without tear-
ing tab.
h. Insert battery cover (plastic cover is attached by a
lanyard).
2. interchangeable one-gallon liquid tank. Tips:
a. Remove the cap leaving
particle strainer in place.
b. Fill as needed and securely
replace cap.
c. Tank does not need to be
removed to fill.
d. Align the tank handle with the guide identified on
the BackPack top label. IMPORTANT: CAREFULLY
APPLY SLIGHT DOWNWARD PRESSURE ON THE
TANK AND TURN INTO THE LOCKING POSITION.
e. Utilize liquids for duration of project or until refill
required. IMPORTANT: CAREFULLY APPLY SLIGHT
DOWNWARD PRESSURE ON THE TANK AND TURN
TO UNLOCK BEFORE LIFTING TO REMOVE.
f. You may exchange tanks with different liquids at
any time.
Keep
this tab to
the left as you
insert the battery
into its compartment
on the BackPack.
3
Assembly & Operating Instructions
CAUTION: TURNING OR LIFTING A TANK FOR
INSERTION OR REMOVAL WITHOUT SLIGHT
DOWNWARD PRESSURE PRIOR TO LOCKING
OR REMOVAL CAN DAMAGE THE TANK OR THE
SYSTEM.
Tank Locked
Handle Alignment
Tank Unlocked
Handle Alignment
