FIGURE 6
Turn the power supply or wall switch on, the light will turn on immediately and
wait for about 1 minute to warm up the unit. After warm-up time is expired
and the light goes off, you may make a walk test and the light will turn on.
This confirms that the wiring was done properly and that the light is working.
Walk through the coverage area. The light will turn on for about 5 seconds
when motion is
detected and turn off shortly after the area is fully vacated.
(2) SETTINGS
TIME ADJUSTMENT
The TIME adjustment controls how long the light will stay on after motion has
been detected.
There are 10 selectable time settings including test ( 3 seconds ) 10, 20, 40, 80,
160 seconds and 5, 10, 20, 40 minutes. Adjust the time control knob clockwise to
increase the turn-off time ( 40 minutes maximum ) or counter-clockwise to
decrease the turn-off time ( 3 seconds minimum ) ( FIGURE 7 )
FIGURE 7
LUX ADJUSTMENT
The LUX adjustment determines at what light level the light will start operating
when you set the sensor to the AUTO mode.
FIGURE 8
Provisionally turn the LUX Control Knob to the edge clockwise at the moon (dusk)
position. (FIGURE 8) In this provisional setting mode, the Motion Sensor remains
inactive during daylight. At dusk when you find it is the LUX level you desired for
operation, simply set the LUX control knob to the position that you tried
satisfactorily.
OPERATION
Automatic Operation
When the sensor detects motion, the light automatically turns on. The built-in
photocell turns
the sensor off and on according to the light level selected by the LUX adjustment.
TROUBLESHOOTING
Light does not turn on
z
Confirm that you have made a correct “wiring connection”.
z
Make sure that the bulbs have not burned out..
Light remains on
z
Make sure the wiring connection is correct.
z
Check if the TIME setting is correct.
about 40min
about 5 sec
