LNK-SPT12V
Hardened Gigabit High Power PoE Splitter
2
V1.0
Installation
DIN Rail Installation
LNK-SPT12V
can be installed on a DIN rail. Installation steps are as follows:
Wall Mount Installation
LNK-SPT12V
also can be installed on a Wall Mount. Installation steps are as follows:
Setup
a) Connect the Ethernet equipment or IP Camera to Data out port of the splitter use the UTP cable.
b) Connect the PoE PSE to the Splitter PoE In port.
c) When the Splitter get the power by POE PSE, the PoE In LED lights illuminate. If the indicators are not on,
check the PoE PSE equipment connection.
d) When 12VDC output, 12V LED lights illuminate. (page 3).
1. Tighten the screws to fix the
DIN Rail plate
1. Tighten the screws to fix the
Wall Mount plate
2. Mount the switch on the wall
or on a flat surface with 2 screws
piercing through the mounting
holes to secure it in position.
Upper part
2. Lock the upper part of the DIN
rail clip on the upper side of the
track. Gently press it until the clip
is securely locked on the track.
Press
