Step 1
Take the installation position map from the accessories bag and put it on the sur-
face of the ceiling or the wall according to the cable exit position. Drill three holes
according to the installation position map and then take three expansion bolts
from the accessories bag and put them into the holes you just drilled.
Step 2
Use the inner hex wrench to remove the three enclosure fastening screws and
then remove the dome enclosure.
Step 3
Adjust the pedestal position according to the cable exit move(ceiling/side). Pull
the cable through the cable side exit at the installation surface and the pedestal.
(Please skip this step if you want to use ceiling exit mode). Line up the screw
holes at the bottom of the pedestal to the expansion bolts in the installation sur-
face. Put three self-tapping screws to expansion bolts and then secure firmly. Now
the pedestal is on installation surface.
Step 4
Adjust the camera module angle to a proper position and then fix the screws to
fasten.
Step 5
Use three enclosure fastening screws to secure the dome housing on
the pedestal.
Fastening Screw
