e-Line Technology ELI-IP5-APTZ21S-30XR, Manual

Page: 15 / 28

8
2
HANG MOUNT INSTALLATION
2.1 Installation Components
Please refer to the following sheet for bracket and components information. See Figure 2-1.
Figure 2-1
2.2 Installation
2.2.1 Installation Requirements
The hang mount speed dome can be installed in the hard construction wall in the indoor or
outdoor environments. Before the installation, please make sure:

The wall is thick enough to install the expansion bolt.

The wall can at least sustain the 8x weight of the speed dome.
2.2.2 Installation Steps
For the speed dome without the straight pole, please refer to the contents below.
Step 1: Dig Holes
Draw the installation holes in the wall according to the holes at the bottom of the connection plate.
Dig the installation holes. Insert the expansion bolts into the holes. (Please note the expansion
bolts are not included in the accessories bag.). See Figure 2-2.
Figure 2-2
Step 2: Installation bracket components.
Straight Pole
Screw thread Connection
Hang Mount Bracket Connection Plate
（
With Cable Exit Slot
）
Hang Mount Bracket Connection Plate
（
Without Cable Exit Slot 2
Adapter Block Safety Rope Hole
Installation Holes