E Instruments BTU700, Quick Manual, Page: 2 / 2

►Analysis config.
Instrument config.
Information
CONFIG/INFO
It is mandatory to perform
the instrument autozero in
clean air.
WARNING!
During autozero DO NOT
insert the gas probe in the
chimney.
Wait: zeroing instrument
KEEP
PRESSED
FOR 2
SECONDS
WARNING
Do not insert the
gas probe in the
chimney
AUTOZERO STARTED
Once the pressure
zeroing is completed
insert the probe in the
chimney and measure
the draught.
0.0 inH
2
O
DRAFT
ZERO KEEP
WARNING
Use P+ positive
inlet
DRAFT
Before zeroing the
pressure it is
mandatory to extract
the probe from the
chimney.
0.1 inH
2
O
DRAFT
ZERO KEEP
AAC PB07
AA SF--A
AAC TA03A
AAC KP01
AA SA05
Smoke
►Ambient CO
Pressure
Tightness test
TC K temperature
▼
MEASUREMENTS
►Print report
Print setup
Print test
PRINT
CO
CO
max
AMBIENT CO
START KEEP
PPM
PPM
0
0
►Smoke
Ambient CO
Pressure
Tightness test
TC K temperature
▼
MEASUREMENTS
The CO ambient gas gives a measurement about
the safety of the environment in which the operator
is working. The concentration values can be
associated to the ongoing analysis or printed
through the Print menu.
CO
max
AMBIENT CO
START KEEP
PPM
0
►Fuel
Measurement units
O
2
Reference
Automatic analysis
Condensation
▼
CONFIGURATION
9 x
▲
Alarms
Autozero/Pump
Operator
Report header setup
►Air T
CONFIGURATION
The measured value of the draft may be associated
to the ongoing analysis or directly printed on the
ticket through the "Print" menu.
Save the measurement
2 x
Save the measurement.
2 x
►Print report
Print setup
Print test
PRINT
BTU700
SN:00001 Ver:1.00
►RefO
2
Auto:001 ▼
O
2
4.2
CO
2
9.3
Xair 1.25
Tf 190.1C
Ta 15.4C
ΔT 74.7C
Eff 83.4
Loss16.6
CO 146p
►Air T
TC K temperature
AIR T
Air T ----- °F
AIR T
Air
T
AIR T
- - - - -
Air T
►TC K temperature
AIR T
68.4
°F
AIR T
QUIT KEEP
68.4
°F
AIR T
QUIT KEEP