LNK-IMC1100-SFP
Hardened 100Base-T to 100Base-X SFP Ethernet Media Converter
3
V1.0
DIN Rail Installation
LNK-IMC1100-SFP can be installed on a DIN rail. Installation steps are as follows:
Wall Mount Installation
LNK-IMC1100-SFP also can be installed on a Wall Mount. Installation steps are as follows:
Setup
1.
Connect one end of each Ethernet cable to its corresponding port on the LNK-IMC1100-SFP.
Connect the other end to the network equipment (IP camera, Switch or PC). Insert the SFP and
connect the optical fiber cable to its corresponding connector.
2.
Connect the LNK-IMC1100-SFP to the power supply. Ensure the power supply in connected to a
power source and the PWR indicator is ON. If not, please ensure that the power cable is connected
properly and the power supply is functioning normally.
3.
After all cables are connected, the indicators will be lit as per port status LEDs (page 5).
1. Tighten the screws to fix the
DIN Rail plate
1. Tighten the screws to fix the
DIN Rail plate
2. Mount the switch on the wall or
on a flat surface with 2 screws
piercing through the mounting
holes to secure it in position.
Upper part
2. Lock the upper part of the DIN
rail clip on the upper side of the
track. Press it until the metal part
move downward and a “click sound
is heard”
Press
