9
EN
Dual Rates and Expos
To obtain the best fl ight performance, we
recommend using a DSM2/DSMX radio capable of
Dual Rates and Expo. The suggested settings shown
here are the recommended starting settings. Adjust
according to the individual preferences after the
initial fl ight.
If using the DX4e or DX5e transmitters, we
recommend activating Expo for smoother control.
For activation and deactivation of the Expo in the
DX4e and DX5e, see the next section.
NOTICE:
Do not set your transmitter travel adjust
over 100%.
If the TRAVEL ADJUST is set over
100%, it will not result in more control movement, it
will overdrive the servo and cause damage.
It is normal for linear servos to make signifi cant
noise. The noise is not an indication of a faulty
servo.
Tip
: For the fi rst fl ight, fl y the model in low rate.
Tip:
For landing, we recommend using high rate
elevator.
Dual Rates
High Rate
Low Rate
Aileron
100%
70%
Elevator
100%
70%
Rudder
100%
70%
Expos
High Rate
Low Rate
Aileron
0%
0%
Elevator
10%
0%
Rudder
0%
0%
DX4e
(Modes 1 and 2)
Activate and Deactivate Expo
1. Put the ACT switch in the down position
(ON) and the Rate switch in the down
position (LO).
2. Push and hold the trainer (bind) button
and move and hold the two sticks (as
shown here) for
activation
(
A
) or
deactivation
(
B
), while powering on
the transmitter.
3. Release the trainer switch and the
control sticks only after a series of
tones sound (ascending tones for
activation, descending tones for
deactivation).
DX4e and DX5e Expo Activation and Deactivation
If you plan to fl y your Gee Bee R2 with a DX4e or DX5e, disconnect the battery from the aircraft before
activating the Expo feature in your transmitter.
Once Expo is activated, it will remain activated for use subsequent power cycles of the transmitter. Once
Expo is deactivated, it will remain deactivated until it is activated again.
A
B
DX5e
(Modes 1 and 2)
Activate Expo
1. Hold the aileron trim switch to the right when
powering on the transmitter.
2. Release the aileron trim switch after a series
of ascending tones to confirm that Expo is
activated.
Deactivate Expo
1. Hold the aileron trim switch to the left when
powering on the transmitter.
2. Release the aileron trim switch after a series
of descending tones to confirm that Expo is
deactivated.