30
E-flite Hawker Sea Fury 400 ARF Assembly Manual
3. Slide the stabilizer into the slot in the fuselage.
Measure the distance from each stabilizer tip to each
wing tip. The measurements must be equal. Adjust
the position of the stabilizer if necessary to correct for
the alignment.
3. Stand back and view the model from the rear. The
wing and stabilizer must be parallel to each other. Lightly
sand the opening in the fuselage for the stabilizer to
correct for any alignment issues.
4. After aligning the stabilizer to the wing, use foam-safe
CA. Double check the alignment one last time before the
CA fully cures. Once the CA cures, snap the joiner wire
back into the bracket at the trailing edge of the stabilizer.
5. Apply foam-safe CA to each side of the hinge, as well
as to the elevator joiner wire.
