EN
Conscendo Evolution1.5m
10
AS3X Control Direction Test (BNF Basic)
This test ensures that the AS3X® control system is functioning properly.
Assemble the aircraft and bind your transmitter to the receiver before
performing this test.
1. Raise the throttle just above 25%, then lower the throttle to
activate AS3X technology.
2. Move the entire aircraft as shown and ensure the control surfaces move in
the direction indicated in the graphic. If the control surfaces do not respond
as shown, do not fly the aircraft. Refer to the receiver manual for more
information.
Once the AS3X system is active, control surfaces may move rapidly. This is normal.
AS3X remains active until the battery is disconnected.
Aircraft
movement
AS3X Reaction
Aileron
Elevator
Rudder
Control Surface Direction
Switch on the transmitter and connect the battery. Use the transmitter to operate
the aileron and elevator controls. View the aircraft from the rear when checking the
control directions.
Ailerons
1. Move the aileron stick to the left. The right aileron should move down and the
left aileron up, which will cause the aircraft to bank left.
2. Move the aileron stick to the right. The right aileron should move up and the
left aileron down, which will cause the aircraft to bank right.
Elevators
3. Pull the elevator stick back. The elevators should move up, which will cause
the aircraft to pitch up.
4. Push the elevator stick forward. The elevators should move down, which will
cause the aircraft to pitch down.
Rudder
5. Move the rudder stick to the left. The rudder should move to the left, which will
cause the aircraft to yaw left.
6. Move the rudder stick to the right. The rudder should move to the right, which
will cause the aircraft to yaw right.
Stick
Movement
Surface
Movement
Aileron
Elevator
Rudder